DS200DTBCG1A

Description

The DS200DTBCG1A GE Connector Relay Terminal Board located in the QD or C cores features 2 terminal blocks with terminals for 110 signal wires along with 2 3-wire bayonet connectors, 1 2-wire bayonet connector and 10 jumpers. The input voltage range is 24 VDC to 125 VDC and the berg jumpers can be removed to aid in troubleshooting. Since the board can have 220 signal wires attached to it, it is best practice that you mount it where the signal wires can be properly routed. Due to the risk of interference the signal wires can not be routed near power cables. The reason for this is that the power cables are considered noisy meaning that they radiate signal noise that can interfere with the accuracy of the signals received by the board. For additional protection, shielded wires can be used to block the interference however, the best solution is to route the power cables separately from the signal wires. If the cables must be routed together, it is best to limit its length by bundling together. The more current a power cable carries the further away the power cable and signal cables should be routed from each other. Ensure that you are routing the signal wires so that they do not interfere with the air flow inside the drive. The reason for this is that the drive is designed so that cool air enters the drive at the bottom of the drive through air vents. The air flows over the heated components and carries away the heat through vents at the top of the drive. IC Spares is available to speak with you via phone or email about all of your automation needs. Our staff can provide pricing information for any part or repair.